Although at first glance this Travertine tiled floor in Oundle appeared to be in decent condition, upon closer inspection however it became very clear that it was suffering from significant pitting issues and had become very dull for a polished stone. While they can’t necessarily be seen in the photographs, the floor had hundreds of small holes across the entire area, along with a few hairline settlement cracks in a few particular tiles.
It is natural for Travertine to become pitted and for small holes to appear over time. To give the stone a smooth appearance these holes are filled at the factory; however, in high traffic areas such as kitchens and living rooms these fillers pop out and the holes quickly fill with dirt and grime, making the floor grubby and difficult to clean.
Needless to say the property owner was keen to have the Travertine restored as quickly as possible to avoid the situation becoming worse.
Cleaning a Travertine Tiled Floor
To begin the restoration, I needed to clean the whole floor to remove the dirt and muck that had become ingrained in the Travertine. I did this using our reliable high alkaline cleaner known as Tile Doctor Pro Clean, which I applied liberally and worked into the stone using the Tile Doctor diamond burnishing pad system, paying special attention to the grout lines.
There are four pads in the system and each burnishing pad is fitted to a rotary machine and ran across the floor in sequence starting with the coarse pad and finishing with the fine pad using a little water to help lubricate.
Sealing a Travertine Tiled Floor
After allowing the new filler to dry overnight, I returned to the property to polish off any excess by hand with a cloth. Following this, I gave the tiles a final polish with the Very Fine diamond encrusted burnishing pad which gave the floor a uniform polished finish.
To protect the floor in the future the last step was to apply a fresh sealant in the form of Tile Doctor Colour Grow, a fanatic product for high-end tiles like Travertine, Limestone and Marble. Colour Grow is a colour enhancing, impregnating sealer which fills the pores in the stone to prevent trapped dirt and also emphasises the natural colours and shades in the process.
The tiles were then left to dry for two hours. I then opted to test for water repellency to check the sealant would provide adequate protection, with a successful outcome. The final picture below shows the finished results: clean, well-protected Travertine tiles with improved sheen.
Phil did an amazing job of repairing the holes and cracks and cleaning the pale coloured grout, which now looks like new. Lovely transformation. I have tried the Tile Doctor Stone Soap and this has given the floor a deep shine. I would gladly recommend Tile Doctor to anyone. Sonia A, Oundle
Sealers protect your floor from staining and enhance the floor of the stone, however they do wear down over time depending on floor traffic and what products are used to clean the floor (don’t use anything even mildly acidic) and this is when dirt can become ingrained in the stone, so if you do want to keep your floor looking its best talk to Tile Doctor their regular maintenance service that will ensure your sealer is kept topped up.